 |
GyroLights
0.1
Oakleaf
|
|
GyroLights
0.1
Oakleaf
|
project specific configuration parameters More...
Go to the source code of this file.
Namespaces | |
| conf | |
Variables | |
| const char | conf::WIFI_AP_SSID_PREFIX [] = "ESP32_" |
| first part of the access point ssid. second part are the last 6 characters of the mac address in hex. More... | |
| const char | conf::WIFI_AP_PW [] = "password1234" |
| password of the configuration access point More... | |
| const int | conf::NUM_LEDS_PER_STRIP = 21 |
| number of leds per individual strip More... | |
| const int | conf::NUM_STRIPS = 1 |
| number of led strips More... | |
| const uint8_t | conf::MAX_BRIGHTNESS = 80 |
| maximum led brightness value. from 0 (always off) to 255 (maximum possible brightness). More... | |
| const int | conf::I2C_TIMEOUT_MS = 1000 |
| const float | conf::WMA_PARAM_ACCEL = 0.5 |
| parameter \(\alpha\) in weighted moving average \((1-\alpha) * newValue + \alpha * oldValue \). lower value: more immediate response, higher value may reduce flicker. in range [0, 1] More... | |
| const int | conf::UNIVERSE = 1 |
| First DMX Universe to listen for. More... | |
| const int | conf::UNIVERSE_COUNT = 1 |
| Total number of Universes to listen for, starting at UNIVERSE. More... | |
| const char | conf::BLE_MASTER_NAME [] = "ESP_32" |
| this has to be the same name for a pair of lights More... | |
| const gpio_num_t | conf::LED_PIN = GPIO_NUM_2 |
| const gpio_num_t | conf::PINS_ROTARY_SWITCH [] |
| all rotary switch pins are pulled up in hardware More... | |
| const gpio_num_t | conf::PIN_LED_CLOCK = GPIO_NUM_19 |
| const gpio_num_t | conf::PIN_LED_DATA_1 = GPIO_NUM_23 |
| const gpio_num_t | conf::PIN_RF_SWITCH = GPIO_NUM_35 |
| Input Pullup in Hardware. More... | |
| const gpio_num_t | conf::PIN_MPU6050_SCL = GPIO_NUM_22 |
| const gpio_num_t | conf::PIN_MPU6050_SDA = GPIO_NUM_21 |
| const int | conf::NUM_PINS_ROTARY_SWITCH = (sizeof(PINS_ROTARY_SWITCH)/sizeof(*PINS_ROTARY_SWITCH)) |
| const int | conf::NUM_LEDS_TOTAL = (NUM_LEDS_PER_STRIP * NUM_STRIPS) |
| const int | conf::I2C_GYRO_ADDR = 0x68 |
| const int | conf::GYRO_ACCEL_SENSITIVITY = 2 |
| sensitivity of the accelerometer range: 0..3 More... | |
| const int | conf::G_VAL = (2 << (15 - 2 - GYRO_ACCEL_SENSITIVITY)) |
| const char | conf::BLE_SERVICE_UUID_str [] = "018c4715-a90b-7ff1-8c4c-aeed790b0a0a" |
| const char | conf::BLE_CHARACTERISTIC_UUID_str [] = "018c4715-f39b-7e59-8928-4a8eda02c6a5" |
project specific configuration parameters
1.9.1